|
|
1. System Name
|
This is the unique name that is used to identify this system in __prod_name. It is the name you chose when you created the hardware system.
|
|
2.
Min Input Voltage
|
This is the smallest voltage that this system is capable of recording, and is the minimum value that can be used for the input range of an AE. This value is based on the hardware being used and cannot be changed.
|
|
3.
Max Input Voltage
|
This is the largest voltage that this system is capable of recording, and is the minimum value that can be used for the input range of an AE. This value is based on the hardware being used and cannot be changed.
|
|
4.
Command IP
|
The IP address and port of the DigitalLynxSX hardware. The IP address is used for creating a TCP\IP connection that will be used to send and receive commands.
|
|
5.
Data IP
|
The IP address and port of the fiber optic network card on the __prod_name PC. This is where the DigitalLynxSX hardware will send acquired data.
|
|
6.
Firmware version
|
The firmware version currently installed on the DigitalLynxSX hardware.
|
|
7.
Sample Frequency
|
The current sample frequency for this system. This value is based on the hardware but can be set using the
-CreateHardwareSubSystem
command. All AD channels on this system will be sampled at this frequency. However, the sampling rate of individual acquisition entities can be changed. See the help section for the type of acquisition entity whose sampling rate you wish to change for more information.
|
|
8.
Total Channel Count
|
The total number of distinct physical signals that the connected DigitalLynxSX hardware can acquire.
|
|
10.
HRS Setup
|
Launches the
HRS Setup
which allows for viewing the current state of all HRS in the system. To change references use either the
CSC
or
Spike Acquisition Entity Properties
. This setting is only available if you have an HRS installed in your system.
|